1,1 SS2 For 5 HP

The SNG electronic  RO Controller Panel is used for operation of the RO plants. The controller has pr-programmed RO operating logic. The control panel can take 6inputs signals, namely: Low Pressure Switch (LPS), High Pressure Switch (HPS), Raw Water Level Switch (RWL), Permeate Tank Level Switch (TWL), 2 Auxiliary Inputs(Used for interlocking with the automatic pre treatment Multi Port Valves). The controller also provides for Conductivity/TDS input. Flow sensing is optional.

The Control panel gives 4control outputs, namely: Raw water Pump(RWP) on/off, High Pressure Pump (HPP)on/off, Flushing Valve Solenoid open/close(230VAC), Dosing Pump on/off (230VAC).Auto MPV power connection is available for Auto mode. Pump Time / Alarm select-able potential free contact is available. Manual Backwash Alert Indication (select-able for Manual Pretreatment) as an alert message is given. The advanced electronics also take care of the required motor protection such as over Voltage , Under Voltage, Over Load,Dry Running with settable parameters

SS2 : Salient features
  • Complete RO Logic Pr-programmed
  • Auto/Manual Operation both supported
  • Pump Overload Protection
  • Pump Dry Run Protection
  • Single Phasing Protection
  • PCB Protection Through Fuse
  • All Safety Features active in both Auto & Manual mode
  • Automatic Membrane Flushing at START, STOP & SET INTERVALS
  • Mimic with 7 LEDs for I/O indication plus 1 Fault LED
  • Dual Line LCD Display
  • Easy to use Menu & Navigation with 5-Key Keypad
  • Conductivity/TDS Monitoring & Control
  • Real Time Clock to Schedule Operational Hours of Plant

 

Technical specification:

Output:- Rwp-3hp 1 phase,high pressure pump 3 hp single phase

Flushing 2hp single phase,2 dosing single phase

Input:-Raw water tank level switch ,permeate tank level switch, LPS, HPS, TDS/conductivity